tdo
Heliman
Location: Germany
My Posts This: Topic Forum | This is how I always routed the servo cables in UNI Expert/2000:
Just some explanations, if necessary:
The receiver sits above the fuel tank, as suggested in the building manual.
Both servos in the right side have their cables directly routed outside
the mech., then along the edge of the fan housing.
Drill a small hole in the fan housing and use a cable tie to secure
the servo cables there.
It looks a bit tricky to prevent the cables from getting into contact
with the gearwheel, it depends a bit on how you route the cables
in that specific area, using a spiral tube around the cables helps.
Never had any issues laying out cables this way.
Regards,
Thilo |
