Ok. That sounds right. I agree with the gear meshing. New gear set installed. Just can't get the new tailcase to close together?? Maybe I am getting old??
Ohhh, I am doing the Hawk sport version for the drive wire. We can't afford torque tubes due to high auto prices Aren't the gears same for Sport or Pro ????????????
Anyway, who knows the thickness of the tailcase bearings?
Yes, Chris you are correct. I mked them and they are the correct bearings. I trimmed the tube spacer to 15.89 mm . The tailcase now closes but the gear mesh is too tight !! Now what ??
I put the proper brass spacer on the tail shaft and filed the output gear ridge down and it is turning. I noticed the inner race of the output bearing was raised a bit. Seems to turn ok now. Used Raptor silicone grease for the gears.
