rsalazar
Elite Veteran
Location: Florida, USA
My Posts This: Topic Forum | Radio Setup:
Transmitter
Hold Scroll Down and Select buttons while powering up
[INPUT SELECT]
Ensure Aux2 set to Aux2 (default unless you’ve previously changed it)
Ensure Gear set to Gear (also default)
Note: This assumes you are controlling gyro gain with either the Aux2 switch (endpoints on Aux2 channel) or the Gyro menus. Either one will work fine.
Power up normally
Press Scroll Down and Select to access menus
[REVERSING SW]
Set channel 5 (Gear) to REV.
[TRAVEL ADJUST]
Ensure GEAR set to +100 and -100 (default unless you’ve previously changed it)
[PROG.MIX1]
GEAR->GEAR
RATE: -25% (Set to amount subtracted from 100 to yield desired gain. Example: -25=75%)
+20% (Always, needed to enable Switchglow with switch down in FM Normal)
SW:F-NR
OFFSET: 0
[PROG.MIX2]
GEAR->GEAR
RATE: -20% (Set to amount subtracted from 100 to yield desired gain. Example: -20=80%)
-100% (Always, needed to disable RPM limit with switch down in FM 1 or 2)
SW:F-S12
OFFSET: 0
[PROG.MIX3]
GEAR->GEAR
RATE: +5 (Mix2 stays active; so this is how much RPM to add to Mix2 position; 80+5=85%)
0% (Always, Mix2 still active in FM 2)
SW:F-S2
OFFSET: 0
The notes above mention specific % gains for the RPM limiter... of course, you really set these with a tach, not a fixed percent.
Receiver
Plug SwitchGlo into Channel 5 (GEAR). Note that SGs come in two flavors, a "5V" and "8V"; you specify when you order. On an 7100R, there are two GEAR slots... plug the SG into the appropriate one, by voltage.
Note: if you do a search you can find additional info - This is the setup That I found in one of my search. |
