v22chap
Veteran
Location: Howe, Indiana
My Posts This: Topic Forum | For time saving ,, I am not going to do a full build pictorial ,,, most can follow manuals .. I will just cover things I found off or hard to understand in the manual .
I first noticed while install servos that the two main shafts were not aligned ... mine were off by 3 or so degrees ... Needs to be dead on I would think .
The next thing was the little ball links ...some have shoulders on them and some had no shoulder ... from looking at the pictures ...the shoulder ones go on the servo arms ... which leaves the non shoulder one to go on the heads .!!???? nothing covered in the manual on that ...
I left the one shown unscrewed to show the no shoulder better and will tighten it down after posting 
P.S.
There were plastic clamp on spacers with the HS 45 servos that are just about right on for making the elevator servo arm line up with the swash plate arm .
Larry C ----------Bergen R/C helicopters |
but it isn't the first time and probably won't be the last ... I rather enjoy trouble shooting first run stuff ,, it makes the simple models a real challenge ... to bad I can't get connected and get them the way you do 
