RunRyder RC Helicopter Topic - tail gearbox gears lash

RR Rated M For Mature

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 875 ONLINE 18 EVENTS SEARCH REGISTER START HERE

1 page

1445 views

POST REPLY

Scorpion Power System	.	RCHover	.	HeliDirect
	.		.

e-MS Composit Hornet > tail gearbox gears lash

thtoyman
Veteran
Location: Gone ,Flying.

My Posts This: Topic Forum

Any one know how to set lashing? What I'm look for is how to do it. My lashing way off. So how dod I move the gaers over?

04-26-2008 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

RUSH
Heliman
Location: Los Angeles, CA

My Posts This: Topic Forum

On the Hornet, you set the tail gear lash by moving the gearbox on the tail boom. Loosen the set screw and move the box forward or back until you get just a little bit of play in the gears, then tighten the screw. I hope this is the info. you're looking for.

04-26-2008 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE

thtoyman
Veteran
Location: Gone ,Flying.

My Posts This: Topic Forum

Not seeing any set screw. I look agian. thanks will try it.

04-27-2008 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

1 page

1445 views

POST REPLY

ReadyHeli	.	Power Helis	.	CANOMOD
	.		.

e-MS Composit Hornet > tail gearbox gears lash

RUSH
Heliman
Location: Los Angeles, CA

My Posts This: Topic Forum

Sorry about that, I wasn't as complete with my information as I should have been. On the older hornets, there is a set screw that goes into the the tail gearbox right in the middle (on the round part). On the Hornet II and X-3D, the tail box has a bolt and nut that is off to the side of the round part which clamps the tail box to the boom.

04-29-2008 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE

1 page

1445 views

POST REPLY

Scorpion Power System	.	RCHover	.	HeliDirect
	.		.

e-MS Composit Hornet > tail gearbox gears lash

Print TOPIC

Advertisers

Subscribe to This Topic