Topic Subscribe
WATCH  1 page2517 viewsPOST REPLY
Futaba-RC . HeliProz . Boca Bearings
. .

Flybarless Rotor Head Systems

 >

CSM fly-bar-less with revlock 30 and carb smart..and with Futaba 14MZ its knock out!

hayabusa

Senior Heliman

uk

Who? has tried this
The CSM fly-bar-less fitted with a revlock 30 is ballistic on take off and tic tocís are a breeze you have a superb rotor breaking effect in this maneuver. I have my pitch set at + - 15% and there is absolutely no signs of bogging because the collective pitch management system just backs the pitch off to maintain rotor speed its awesome. The Hyper engine runs absolutely sweet as a nut using the carb smart and maintains good consistent power through out maneuvers.The 14MZ also has an acceleration program for your pitch just try it in one of your idle upís the pitch pump is hyper fast and is just a mental set up with ATVíS on aileron elevator and pitch at 140% this will kick your adrenalin in gear you wont stop till you have run out of juice. hayabusa

03-10-2008 Over year old.
JKos

rrProfessor

Redondo Beach, CA

> because the collective pitch management system just backs the pitch
> off to maintain rotor speed its awesome.

How does this occur? Is there connection between the RevLock 30 and the CycLock?

Edit: Nevermind... Hadn't read up on the RevLock 30 yet.

- John

RR rules!

03-10-2008 Over year old.
hayabusa

Senior Heliman

uk

HI Jkos yes there is a connection between cyclock and revlock 30 which allows you to use more collective range than a conventional governor, which also allows you to use the power limit's of your engine and then the revlock 30 modulates the maximum collective pitch which prevents the engine bogging down its just marvelous. hayabusa

03-10-2008 Over year old.
Flying Tivo

Key Veteran

Monterrey,NL,Mexico

Haya:

What is your setting on the acceleration menu? Are you using it only on pitch or also on ail and elev? Does the new revlock need the cyclok or can the pitch limiter be used without it?

Felipe

03-15-2008 Over year old.
JKos

rrProfessor

Redondo Beach, CA

> Does the new revlock need the cyclok or can the pitch limiter be
> used without it?

If you have a CCPM machine, you'll need the CycLock.

- John

RR rules!

03-15-2008 Over year old.
Flying Tivo

Key Veteran

Monterrey,NL,Mexico

Ecccpm or Mcccpm? i dont need cyclok for an R90 flybarless. So my question is can i use the revlock with limiter for pitch?

Felipe

PD John thats where your csm is going, Ail i think

03-15-2008 Over year old.
DEMONjoe

Senior Heliman

Germany

Anything about the pricing?

Cheers,

Joe

03-19-2008 Over year old.
HOMEPAGE  
hayabusa

Senior Heliman

uk

Hi flying Tivo the settings for the acceleration program for my 600n are active position left 50% right 50% Örate low = 50% rate high = 50%..Dumping = 40% make sure your servoís are not bouncing or being stalled with your mechanical set up limits or binding you will like it . The 600n is 3 CCPM so all 3 servos function on acceleration program which is hideously quick, on say the raptor 90se I would suggest a very powerful servo on pitch if it was myself I would put 2 very powerful servos on pitch using acceleration program. Flying Tivo/Jkos the revlock 30 does not need the cyclock for collective limiter on mechanical set up but on CCPM it requires the cyclock 1. The revlock 30 is RRP £59.95and the cyclock 1 is RRP£49.95 if you shop around they can be less I use these on all my CCPM helicopters if you are on 35/72 mhz on CCPM the cyclock gives you g3 or 2.4ghz speed .hayabusa

03-19-2008 Over year old.
WATCH  1 page2517 viewsPOST REPLY
Encore RC . ExperienceRC . JR AMERICAS
. .

Flybarless Rotor Head Systems

 >

CSM fly-bar-less with revlock 30 and carb smart..and with Futaba 14MZ its knock out!

 Print TOPIC Advertisers 

Topic Subscribe

Wednesday, October 22 - 10:36 pm - Copyright © 2000-2014 RunRyder   EMAILEnable Cookies