RunRyder RC Helicopter Topic - How to take a bolt out from a spindle shaft?

RR Rated M For Mature

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 790 ONLINE 80 EVENTS SEARCH REGISTER START HERE

1 page

235 views

POST REPLY

XHELI.COM	.	Advantage Hobby	.	Revolution Models
	.		.

HIROBO Turbulence - SDX - Freya - Sceadu > How to take a bolt out from a spindle shaft?

sir777
Senior Heliman
Location: Moscow, Russia + Lloret de Mar (Girona), Spain

My Posts This: Topic Forum

Hi everybody! I decided to change a spindle shaft. What it is the best way to take out a bolt from it? I took bolt out from it with a socket wrench while holding the second one with another socket wrench. And now i want to take the second bolt out. I know it is sounds stupid, but I don't have any idea. I tried holding it with pliers, but I only scratched it. Thank you for help.

03-05-2005 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

sir777
Senior Heliman
Location: Moscow, Russia + Lloret de Mar (Girona), Spain

My Posts This: Topic Forum

Sorry guys, i solved my problem by heating the spindle and bolt a bit. Probably too much locktite. Thank you.

03-05-2005 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

new sceadu
Veteran
Location: LEICSTERSHIRE

My Posts This: Topic Forum

Hi
if you have a spare nut then put 2 on the same side and tighten them onto each other not the thread stop. then hold the inner most nut and undo the the nut on the other side that your stuck with. then undo the 2 nuts and they should spin off by hand.

03-05-2005 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

sir777
Senior Heliman
Location: Moscow, Russia + Lloret de Mar (Girona), Spain

My Posts This: Topic Forum

Thank you for tip. I didn't have any spare nuts.

03-05-2005 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

Dr.Ben
rrProfessor
Location: Richmond, VA, USA

My Posts This: Topic Forum

Stick the end without the bolt into a drill chuck then tighten, then heat the other end a little. It'll come right out without marring the shaft.

Ben MInor

03-05-2005 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE

sir777
Senior Heliman
Location: Moscow, Russia + Lloret de Mar (Girona), Spain

My Posts This: Topic Forum

Thanks, Dr.Ben! I will try this in future.

03-05-2005 Over year old.

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

ChrisLaFollette
Veteran
Location: Altha, FL

My Posts This: Topic Forum

I grab mine in the middle of the shaft and grab it with a big pair of pliers, squeeze like he** and back that bolt out!!!