the Wasp
rrProfessor
Location: Vt
My Posts This: Topic Forum | About 4 week ago I greased my Head Dampers with Dielectric Grease, it worked good, or maybe to good !!,,, well, last week I noticed every once and a while I would see my Hawk V2 make a round circle movement (or letter O) with it's nose, and this week it's doing it more !!,,, well, I notice my Head Dampers are cut, so I took them off and what I found was the Dampers are cut where they meet the Head Block opening, the edge on the Head Block is sharp on the inside where the two meet,,, and where the washers meet the Dampers the Dampers have bad ware marks on them,,,,,,,,,, at first I was thinking it was the Dielectric Grease fault , but as I'm writing this I remembered that I did have some ground strikes with the main blades when I crashed, so this must be when I got the cuts in my dampers,,, what do you guys think ?!?!
Jim |
