I've found some blades that fit a heli that I no longer own. I have another heli that they will fit in length but the blade grips are narrower than the blade root.
Has anyone found a cost effective solution to cutting the root down and ending up with a surface that is perpendicular to the blade mounting hole? Other than setting them up in an industrial milling machine that is.
The blades are V-Blade 710 mm that have a raised fiberglass(?) washer glued/glassed(?) to them at the root. I have found that the brass tube in the blade mounting hole can be easily removed, cut down and reinstalled.
I would also be interested in comments on "milling" down only one face of the root. Can this make anything lopsided?
If you get an answer, it'll help me too. I got a set of blades with the last used heli I bought that were "just a little" too wide for the blade grips!! so............BUMP!!
Buyer beware! RunRyder cannot vouch for any seller's
or buyer's credibility and will not accept responsibility
for any transactions resulting from the use of this site.
)
)
)
){kind=small}
){kind=small}
){kind=small}
)
)
)
)
){kind=small}
){kind=small}
){kind=small}
){kind=small}
)
)
)
)
){kind=small}
){kind=small}
){kind=small}
){kind=small}
)
){kind=small}
)
)
)
){kind=small}
){kind=small}
){kind=small}
)
)
)
)
){kind=small}
){kind=small}
){kind=small}
){kind=small}
)
)
)
)
){kind=small}
){kind=small}
){kind=small}
){kind=small}
)
)
){kind=small}
){kind=small}
)
)
)
){kind=small}
){kind=small}
){kind=small}
)
)
)
){kind=small}
){kind=small}
){kind=small}
)
){kind=small}
)
)
)
)
){kind=small}
){kind=small}
){kind=small}
){kind=small}
)
)
)
){kind=small}
){kind=small}
){kind=small}
